McGraw Hill deeply integrates into MyFIRE, allowing for
direct links to be added to the content page. These links will navigate the
student or instructor directly to that assignment. With each McGraw Hill link,
a grade item will be created to facilitate automatic grade syncing (if there is
no point value assigned, no grade item will be created). The following tutorial
demonstrates how to deploy McGraw Hill links directly into MyFIRE.
Note: This tutorial assumes that the course has already been
integrated/connected with McGraw Hill and you are an editing instructor.
1. Navigate to the desired course.
2. Navigate to the desired content module.
3. Select Add Exisiting.
4. In the mini-menu, select McGraw Hill Connect
LTIA.
5. In the pop-up window, select the first link - Go
to my Connect Section.
6. A new tab will load with your Connect section.
Navigate to the Assignments page and locate the desired assessment.
7. Select the checkbox to the left of the desired
assessment titles that have not been deployed. Note: Hidden or unassigned
assessments cannot be deployed.
8. If needed, scroll up to the top of the section
and select the three vertical dots on the right-hand side in the blue banner.
9. In the mini-menu select Deploy to Brightspace.
10. The
page will refresh and prompt you to select a Grade Type (Best and Last).
11. Then,
select Deploy in the bottom right.
12. The
tab will close and show MyFIRE with the same pop-up as before stating ‘You are
almost done! Do not close this page’. Note: Please do not navigate away from
the page and wait until the pop-up disappears. If the page is navigated away
from the McGraw Hill links will not deploy.
13. The
page will refresh and the assessment links will be within the desired module
and a grade item will be created. If needed, organize the new links and the
grade book as desired.